Mounting Blocks

Plans fail when there is no consultation, But there is accomplishment through many advisers

Back from more trips; this time Betws-y-Coed with Senior Management.

In between, this trip and that, I’ve been doing what I can. The final step before completing the Base is to clean up the Mounting Blocks that support The Bed. This is them dirty…

20140428-092514.jpg
Some pictures of the threaded rod as it comes out the underside…

20140428-093147.jpg
There’s a lot of that paint from the Oil Tray sticking to things, like this grommet…

20140428-093436.jpg
Some oily gunge in one of the holes…

20140428-093651.jpg

Every part was given the GUNK treatment…

20140428-093743.jpg
…as was the two Blocks…

20140428-093819.jpg
All came out nice. Clockwise from the threaded rods, the other parts are eight nuts, four rubber grommets, or seals, and four bed levelling nuts.

20140428-094540.jpg
Notice the rod on the left is bent? It also had a damaged thread…

20140428-094917.jpg
A simple fix with a very fine saw sharpening file…

20140428-095014.jpg
To straighten the rod, first I clamped it in the vise and wound on three nuts tightly…

20140428-095338.jpg
Then, using a wooden block to avoid damaging the nuts, I tapped it with Big Hammer to take out the kink. Finished off on the anvil part of the vise…

20140428-095559.jpg
…being very careful not to hit the threads. This is the rod before…

20140428-095652.jpg
…and after…

20140428-095726.jpg
This is a reasonably clean threaded hole…

20140428-100355.jpg
The large diameter is for the levelling nut. There is a smooth sided hole through the levelling nut through which passes the threaded rod into the small diameter hole at the bottom.The threaded rods and their bolts are for securing and the levelling nuts are for just that, levelling The Bed. Why? I’m not that sure yet. Something about turning a parallel shaft. No doubt I’ll find out on the beginner’s course I intend to go on.

I thought I’d strip the paint from the Blocks. The trouble was, the paint stripper didn’t budge it at all. And this after several applications. Not even any blistering. I tried scraping, as per the Oil Tray, but the scraper couldn’t get under it. Perhaps it’s not paint? Eventually I gave up, washed them and left it at that…

20140428-101550.jpg
Next post, assembly.

Advertisements